Rising from the ashes

[Blank Slate]

I didn't realize how good those headers I gave you were. They look sweet!!!

Huge improvement over the old 4-1

[mack]

Post

another picture more from the side so that we can see the hangers and the weld connection Pablo.

[Blank Slate]

[Blank Slate]

Sanding and polishing time

[mack]

Pablo

Look here:
http://www.how-to-build-hotrods.com/soda-blaster.html

[tomcos67]

That's impressive.!!! Thanks for tip..!!

[Blank Slate]

Awesome Mack

[Blank Slate]

Not bad for 30 minutes of work?

[tomcos67]

On the side covers I usually just use black sharpy ,put the black back in Yamaha ,works fine.

[HalfCentury]

Not bad for 30 minutes of work?

Did you soda blast? If so, how much soda did you use?

[Blank Slate]

Did you soda blast? If so, how much soda did you use?

Some guy down the street from me does restoration work and said bring a cover to me and I'll show you how its done. First he used a belt sander to get the deep scratches at the bottom of the cover level. Next gave me a rag and paint remover to scrub the paint off. Then he used a scotch-brite pad and finally a he worked it againsta polishing wheel while applying chalk to the pad. At least that's what I remember the steps being. He said he could put a coat on it when it's done.

[madmax-im]

Lookin' good Pablo...

[Blank Slate]

Lookin' good Pablo...

Thanks Ben.

Been working on the covers and shining up the bolts. Had the idea of buying stainless steel ones but I'm not finding a complete list of measurements for them. I went to a specialty store with my measurements and bought 6 types of bolts, none of them fit. Thread size was too small. Imperial metric, I measured in cm's, the store has inches, man I give up and will just dremmel the existing ones as best I can lol

[Blank Slate]

On the side covers I usually just use black sharpy ,put the black back in Yamaha ,works fine.

Or can of spray paint

[Radioguylogs]

Alternator Cover is Beautiful

Pablo:

I think your clutch cover is getting jealous.

About the SS bolts:

This post contains a list of the bolt sizes from Crazy Steve:
http://www.xs11.com/forum/showthread...tainless+bolts

I had lots of help from the community deciding to go stainless:
http://www.xs11.com/forum/showthread...ight=stainless

I got my SS bolts online from BoltDepot.com

26 pcs 6mm x 35mm @ $0.29 -> $7.54
26 pcs 6mm x 25mm @ $0.22 -> $5.72
14 pcs 6mm x 20mm @ $0.21 -> $2.94

Total $16.20 + $11.01 shipping (ouch) = $27.21

Don't give up you really want to go SS!