Tweet
What do you use to adjust the idle mixture screws on your carbs? Any particular brands? I see Motion Pro has a 90 degree screwdriver but will that fit? Or just go to hardware store and get thin standard tip?
-
1980 XS1100 SG
Inline fuel filters
New wires in old coils-outer spark plugs
160 mph speedometer mod
Kerker Exhaust
xschop K & N air filter setup
Dynojet Recalibration kit
1999 Kawasaki ZRX1100
1997 Jeep Cherokee 4.5"lift installed -
The only reason you would need 90 deg, is to adjust with the tank on, I use a long skinny flathead with the small tip and adjust from above the frame.
Similar to this...
https://www.amazon.com/Screwdriver-C...93&sr=8-1&th=1
Or make your own...Last edited by bikerphil; 08-13-2022, 08:35 PM.2H7 (79)
3H3
"If it ain't broke, modify it"
☮ -
I always take the tank off and flip it around. Front to back.Jeff Korn
Original Owner 79XS1100 E
Yamaha Warrior has come and goneComment
-
I have the motion pro 90 degree tool but use that on carbs with air screw on bottom. On my XS11 i use one of my cut-off short screwdrivers with tank on or a combination of that and a long skinny with tank off.
Beware when installing a kit, be sure all parts are exactly the same, often they are not. This is why i usually soak all original brass overnight and reuse itComment
-
Jet Kit has been in the bike since around 1986 so no need to change anything around other than cleaning.1980 XS1100 SG
Inline fuel filters
New wires in old coils-outer spark plugs
160 mph speedometer mod
Kerker Exhaust
xschop K & N air filter setup
Dynojet Recalibration kit
1999 Kawasaki ZRX1100
1997 Jeep Cherokee 4.5"lift installedComment
Comment