i just picked up a set of k&n filters wondering what mods need to be done with the intake. also got a question about the engine advanced mechanism does the vacuum advance connect into the air box? thanks for the help
Announcement
Collapse
No announcement yet.
pod filter help
Collapse
X
-
To swap to pods, you'll need to rejet/resync the carbs. You'll need to go up one or two jet sizes too; this will depend on what type of exhaust you have fitted.
As for the vacuum advance, that connects to the number two carb (not the intake); the nipple is on the top right near the manifold.Fast, Cheap, Reliable... Pick any two
'78E original owner - resto project
'78E ???? owner - Modder project FJ forks, 4-piston calipers F/R, 160/80-16 rear tire
'82 XJ rebuild project
'80SG restified, red SOLD
'79F parts...
'81H more parts...
Other current bikes:
'93 XL1200 Anniversary Sportster 85RWHP
'86 XL883/1200 Chopper
'82 XL1000 w/1450cc Buell, Baker 6-speed, in-progress project
Cage: '13 Mustang GT/CS with a few 'custom' touches
Yep, can't leave nuthin' alone...
-
Vacuum advace hose goes to port on front side of number 2 carb. Could'nt run fast enough to give me a set of pods, besides sometimes causing a tuning daymare. No mods if a Standard cept for a vented breather to replace the hose that goes crankcase vent up to front top of air box. Also, go back and edit your profile with the yr. scoot we're dealing with and your location as you see on the other members. Welcome to the XSessive madness!81H Venturer1100 "The Bentley" (on steroids) 97 Yamaha YZ250(age reducer) 92 Honda ST1100 "Twisty"(touring rocket) Age is relative to the number of seconds counted 'airing' out an 85ft. table-top.
Comment
-
pod filters
i have a kerker four to one exhaust right now. 110outside main jets 120 inside a 42.5 pilot jet. Was going to dyno tune but have to wait till fall due to construction.
p.s. hope to have bike back together within a few weeks will post lots of picturesLast edited by L0rdexpectati0n; 04-19-2011, 06:35 PM.1980 xs1100sg
Comment
-
Hey Lord,
You've got an 80 SG...checked your PROFILE to find it, would be good to put in your signature in future so folks don't have to check the profile.
Surprised that you have the 110/120 combo....most have found the same size across all four. Yamaha did away with the staggered jets early on, despite what the manuals say. The 81 came with 110 straight across, and a 120 is 4 sizes up. What do your plugs look like on the cylinders with the 120's? If you have good color, or even a bit sooty with the 120's, then that may be all you need, and just get 2 more to replace the 110's. It's a bit of a trial and error process sometimes!
T.C.T. C. Gresham
81SH "Godzilla" . . .1179cc super-rat.
79SF "The Teacher" . . .basket case!
History shows again and again,
How nature points out the folly of men!
Comment
-
If you do get a dyna jet kit, stick with the stage 1 kit, anything else is too much for a basically stock engine.Nathan
KD9ARL
μολὼν λαβέ
1978 XS1100E
K&N Filter
#45 pilot Jet, #137.5 Main Jet
OEM Exhaust
ATK Fork Brace
LED Dash lights
Ammeter, Oil Pressure, Oil Temp, and Volt Meters
Green Monster Coils
SS Brake Lines
Vision 550 Auto Tensioner
In any moment of decision the best thing you can do is the right thing, the next best thing is the wrong thing, and the worst thing you can do is nothing.
Theodore Roosevelt
Comment
-
Originally posted by L0rdexpectati0n View Poststock for nowNathan
KD9ARL
μολὼν λαβέ
1978 XS1100E
K&N Filter
#45 pilot Jet, #137.5 Main Jet
OEM Exhaust
ATK Fork Brace
LED Dash lights
Ammeter, Oil Pressure, Oil Temp, and Volt Meters
Green Monster Coils
SS Brake Lines
Vision 550 Auto Tensioner
In any moment of decision the best thing you can do is the right thing, the next best thing is the wrong thing, and the worst thing you can do is nothing.
Theodore Roosevelt
Comment
Comment