Covered / unheated storage
Collapse
X
-
More questions
OK, I reduced the height of the seasonal shelter so it would fit under the house's eve and right up to the garage door. I have 3 bikes in there now and they were covered with cotton sheets. This evening when I went out to seal the end of the shelter to the house I noticed that the sheets were DAMP. I removed them and will guess that in an outdoor storage situation their better off just left as is. So, should I run a small household fan in there all winter to keep air moving around? Set it to sweep across the air space?
Rob
KEEP THE RUBBER SIDE DOWN
1978 XS1100E Modified
1978 XS500E
1979 XS1100F Restored
1980 XS1100 SG
1981 Suzuki GS1100
1983 Suzuki GS750S Katana
1983 Honda CB900 CustomComment
-
Light bulb
I would add a light bulb ...it might heat the enclosed space enough to keep condensation down...
JohnJohn is in an anonymous city with an Alamo (N29.519227,W-98.678980)
Go ahead, click on the bikes - you know you want to...the electrons are ready.
'81 XS1100H - "Enterprise"
Bob Jones Custom Navy bike: Tkat brace, EBC floating rotors & SS lines, ROX pivot risers, Geezer rectifier, new 3H3 engine
"Not all treasure is silver and gold"Comment
-
RobKEEP THE RUBBER SIDE DOWN
1978 XS1100E Modified
1978 XS500E
1979 XS1100F Restored
1980 XS1100 SG
1981 Suzuki GS1100
1983 Suzuki GS750S Katana
1983 Honda CB900 CustomComment
-
Fast, Cheap, Reliable... Pick any two
'78E original owner - resto project
'78E ???? owner - Modder project FJ forks, 4-piston calipers F/R, 160/80-16 rear tire
'82 XJ rebuild project
'80SG restified, red SOLD
'79F parts...
'81H more parts...
Other current bikes:
'93 XL1200 Anniversary Sportster 85RWHP
'86 XL883/1200 Chopper
'82 XL1000 w/1450cc Buell, Baker 6-speed, in-progress project
Cage: '13 Mustang GT/CS with a few 'custom' touches
Yep, can't leave nuthin' alone...Comment
-
RobKEEP THE RUBBER SIDE DOWN
1978 XS1100E Modified
1978 XS500E
1979 XS1100F Restored
1980 XS1100 SG
1981 Suzuki GS1100
1983 Suzuki GS750S Katana
1983 Honda CB900 CustomComment
-
I have a 10 x 20 x 8 canopy type garage same as you have pictured or pretty much so. I laid 3/8's OSB on the floor and rolled the bikes in. The OSB was only there because I did not want the bikes falling over from the stands sinking into the gravel. I have used it a couple of years now with no heat, no bulbs , no attention etc. I have had no problem with rust or anything else using simple plain cold covered storage. Of course here in sunny Alberta we get few days where it gets warm enough to have higher humidity. Frozen air does not hurt bikes...lol.2-79 XS1100 SF
2-78 XS1100 E Best bike Ever
80 XS 1100 SG Big bore kit but not fully running yet.
Couple of more parts bikes of which 2 more will live!Comment
-
I have a 10 x 20 x 8 canopy type garage same as you have pictured or pretty much so. I laid 3/8's OSB on the floor and rolled the bikes in. The OSB was only there because I did not want the bikes falling over from the stands sinking into the gravel. I have used it a couple of years now with no heat, no bulbs , no attention etc. I have had no problem with rust or anything else using simple plain cold covered storage. Of course here in sunny Alberta we get few days where it gets warm enough to have higher humidity. Frozen air does not hurt bikes...lol.
RobKEEP THE RUBBER SIDE DOWN
1978 XS1100E Modified
1978 XS500E
1979 XS1100F Restored
1980 XS1100 SG
1981 Suzuki GS1100
1983 Suzuki GS750S Katana
1983 Honda CB900 CustomComment
-
As long as the canopy/tent is not sealed up well it should not get all that moist. Mine has snow blowing in under the edges a bit but nothing seems to get damp. It has been unusually mild here as well so I may be proved wrong. Not like that would be the first time for that either.2-79 XS1100 SF
2-78 XS1100 E Best bike Ever
80 XS 1100 SG Big bore kit but not fully running yet.
Couple of more parts bikes of which 2 more will live!Comment
-
I was out there Christmas evening after dinner because the garage was the smoking area for guests and I saw that the bikes in the shelter are covered with FROST. That being the case i do not think I will be putting my finished bikes out there. There was also frozen moisture droplets on the ceiling.
RobKEEP THE RUBBER SIDE DOWN
1978 XS1100E Modified
1978 XS500E
1979 XS1100F Restored
1980 XS1100 SG
1981 Suzuki GS1100
1983 Suzuki GS750S Katana
1983 Honda CB900 CustomComment
-
It will definately help, as the secret to condensation control is air movement, however cross-flow air is what you want. Set up an air inlet at one end, an air exhaust at the other and set your fan to blow out the exhaust. That will drag air in the intake and replenish it all the time. You'll have a difficult time controlling it at sub zero (< 32 ) temperatures due to humidity levels but frost on it's own isnt going to hurt anything, as long as things dry out quickly when the temp warms up, and moving air will speed that up dramatically. Quickest way to heat air is to dry it out, and it takes much less energy to heat dry air than it does to heat damp air.1980 SG. (Sold - waiting on replacement)
2000 XJR1300. The Real modern XS11. Others are just pretenders.
Woman (well, my wife anyway) are always on Transmit and never Receive.
"A man should look for what is, and not for what he thinks should be" Albert Einstien.Comment
-
It will definately help, as the secret to condensation control is air movement, however cross-flow air is what you want. Set up an air inlet at one end, an air exhaust at the other and set your fan to blow out the exhaust. That will drag air in the intake and replenish it all the time. You'll have a difficult time controlling it at sub zero (< 32 ) temperatures due to humidity levels but frost on it's own isnt going to hurt anything, as long as things dry out quickly when the temp warms up, and moving air will speed that up dramatically. Quickest way to heat air is to dry it out, and it takes much less energy to heat dry air than it does to heat damp air.
RobKEEP THE RUBBER SIDE DOWN
1978 XS1100E Modified
1978 XS500E
1979 XS1100F Restored
1980 XS1100 SG
1981 Suzuki GS1100
1983 Suzuki GS750S Katana
1983 Honda CB900 CustomComment
-
Boeshild
This is the best I have found, invented for Boeing jet parts. Spray it on and wash it off when ready to use the bike / part
Shield your gear from rust and corrosion with Boeshield T-9ยฎ, the ultimate waterproof lubricant for bikes, boats, tools, and more.
Hi Rob,
looks like we're back to fizzing the bikes with the rust inhibitor of your choice, putting them on a tarp to reduce rising damp, covering them with el-cheapo bike covers spaced up with cardboard & with a 60Watt light bulb inside.
BTW, no basement is fully furnished until it has a bike as it's centrepiece.1979 XS1100 Special (Mad Max, OEM) Current
1980 XS1100 Special
1990 V Max
1982 KZ750 LTD Twin
1986 700 FZR Yamaha Fazer (faster then expected)
1979 XS750 Special (my 1st Special)
1974 CB750-Four
Past/pres Car's
1961 Catalina 389/1970 Torino GT 351/1967GTO 12to1 comp./ Roller cam/ T-10/ 456 gear/Tri-power/1967 GTO 400, 1969 Camaro, 1968 Z28, 2001 BMW M Roadster 0 to 60 in 4.5 sec. Jaguar XK8Comment
Comment