Broke off terminal in stock fuse panel

[LugNut]

Had to pull 30 Amp original fuse from 42 year old bike...so you can guess what happened....

Quick/easy way to get this to work? Just wanted tobstart to run gas+StaBill through carbs for winter storage...while cranking headlight and meter were off then on then off...pulled side cover and fuse was bad. When i grabbed it gently the one side of prong/holder snapped off clean. See pics.

I know how to fix it correctly (have new fuse block and all the goodies)....BUT what is the best fast way to fix it so i can ride it a tiny bit and put away for winter?

[skids]

May as well make a little time to get that new fuse block installed…

[cajun31]

May as well make a little time to get that new fuse block installed…

same thing I suggested, however it turns out he is not wanting to keep the bike and will leave it up to whoever purchases it to invest in and do the proper fix.

[shutchis]

Buy an in-line fuse holder at an auto parts store. Attached the leads to the fuse block wiring. Soldering the connection is probably best solution. By sure to purchase a fuse. This is a quick and easy solution and should get you rolling. You could use alligator clips and jumper wires without a fuse but it's not my recommendation.