oil cooler hoses needed $$$$$$$

[gaffer77]

Hi i need the 2 brackets to hold the cooler pipes to the frame ,i got the round ones on the hoses just need the 2 that they attatch to and then mount to the engine mounts on the frame.

looking for original so dont want to fabricate any

will pay $30.00 FOR 2 GOOD UNNS!!

OR SWAP SOMETHING i have allot of xs bits and pieces

thanx for reading this!!

[pggg]

Gaff, 2 small bolts/nuts, an empty baked beans can, a drill, a pair of tinsnips and a squirt of paint. 2 strips 2cm x 10cm. As for original - I wont tell if you dont.

[gaffer77]

Just a shame to do it when its something so stupid

Tryin to get it all back original as poss

got a fetish for it!! like the challenge of finding the bits as well!!

[rickmcdougald]

Hey Gaffer,
Can you send us a picture of the items that you want to secure together?
RLMcD

[gaffer77]

IN the picture you will see the small brackets i need

they have a top and bottom hole,they are a T shape

the ' T ' shape is only about 1.5 inches long the tab fixes to
a round clip with a tab on it which is connected to the hose

I got the ones on the hoses

The reason i don't want to fabricate is because these are shaped
to angles to the frame and they pull the hoses tight in and away from the exhaust down pipes JUST!!!!

part of an engine mount may do it ,just got to get one to see???

[pggg]

Gaff, if you have no luck, the T's will be very easy to snip from 1mm tin plate - flexible to bend an angle on & still stiff. There are a pair of upper tabs too. (the ones I described previous) 1mm plate would be preferable to a baked bean tin though!

[gaffer77]

Hi i got four round clips on the hoses

,,where do the top ones attatch to??

think i will make some and see how they look

only putting a cooler on as the bike looks wierd with a big gap!!