If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
the final and middle drive use the same allen wrench. why not cut it down so that when inserted to the fill hole it could read the level of gear oil? save time save money and use the same tool to check your fluid level!
First bike was an: 1978 XS1100
Second bike is an FJR1300.
Now I'm restoring a '79 XS1100.
Tweet
Comment