Announcement

Collapse
No announcement yet.

Stuck clutch

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Stuck clutch

    I started my 81 today and it runs great but the clutch seems to be stuck. When I click it into gear with the clutch all the way in the motor dies. I have tried rocking it in first gear with the clutch in and it wont free up.
    The bike has sat for about 2 years
    81 XS11

  • #2
    Put the bike on the side stand, remove the clutch cover, pull all the clutch plates out, clean them, and reverse procedure. I just got done doing that to a bike that has been sitting for about 10 years.
    Ray Matteis
    KE6NHG
    XS1100 E '78 (winter project)
    XS1100 SF Bob Jones worked on it!

    Comment


    • #3
      Could be your cable is not traveling fully inside the sheath since it has sat for two years. Or the linkage on the other end is not traveling fully.

      If you can unhook the clutch cable at the lever put oil into the sheath let it soak, put some more in there and see if you can loosen it up.

      Or remove the cable entirely so you can slide it back and forth while you add the oil.

      Could be the clutch plates are froze because of mother time.

      Those are things that come to mind.
      Howard

      ZRX1200

      BTW, ZRX carbs have the same spacing as the XS11... http://www.xs11.com/forum/showthread.php?t=35462

      Comment


      • #4
        Stuck

        Warm the bike up. Keep rocking it until it frees up. Not uncommon for this to occur.
        1981 XS1100H Venturer
        K&N Air Filter
        ACCT
        Custom Paint by Deitz
        Geezer Rectifier/Regulator
        Chacal Stainless Steel Braided Brake Lines
        Chrome Front Rotor & Caliper Covers
        Stebel Nautilus Horn
        EBC Front Rotors
        Limie Accent Moves On In 2015

        Mike

        Comment


        • #5
          Good idea, let the oil get up to temperature and heat may be your friend.

          I don't know if this would work... Put it up on the center stand, point it in a direction it can roll forward, click it up into 3rd 4th or 5th gear pop it off the center stand with you in the saddle and see if the forward momentum in a higher gear will help you too.
          Last edited by Bonz; 05-29-2020, 09:12 PM.
          Howard

          ZRX1200

          BTW, ZRX carbs have the same spacing as the XS11... http://www.xs11.com/forum/showthread.php?t=35462

          Comment


          • #6
            Get on the bike ready to ride, put in first gear. Turn on the ignition and push the starter button. When you start moving and the engine starts, it should quickly free up.
            2H7 (79) owned since '89
            3H3 owned since '06

            "If it ain't broke, modify it"

            ☮

            Comment


            • #7
              I am going to pull the cover and check the plates
              I dont want to do any damage by rocking it
              81 XS11

              Comment


              • #8
                Didnt find anything wrong. Just a bunch of stuck plates.
                81 XS11

                Comment


                • #9
                  You did find something - peace of mind.
                  -Mike
                  _________
                  '79 XS1100SF 20k miles
                  '80 XS1100SG 44k miles
                  '81 XS1100H Venturer 35k miles
                  '79 XS750SF 17k miles
                  '85 Honda V65 Magna ~7k miles
                  '84 Honda V65 Magna 48k miles (parts bike)
                  '86 Yamaha VMAX 9k miles

                  Previous: '68 Motoguzzi 600cc + '79 XS750SF 22k miles +'84 Honda V65

                  Comment


                  • #10
                    Originally posted by leggman1 View Post
                    Didnt find anything wrong. Just a bunch of stuck plates.
                    Soooooo... Ride report! Come on, tell us that you got it fixed.
                    Howard

                    ZRX1200

                    BTW, ZRX carbs have the same spacing as the XS11... http://www.xs11.com/forum/showthread.php?t=35462

                    Comment


                    • #11
                      I did ride it around my neighborhood and it seems to be fixed.
                      I guess thats what I get for letting it sit for so long
                      81 XS11

                      Comment


                      • #12
                        Hey look on the bright side, the bike has now told you it wants you to ride it more often! Nothing like being more regular with that.
                        Howard

                        ZRX1200

                        BTW, ZRX carbs have the same spacing as the XS11... http://www.xs11.com/forum/showthread.php?t=35462

                        Comment

                        Working...
                        X