Announcement

Collapse
No announcement yet.

Introduction; trying to work out the kinks

Collapse
X
Collapse
 
  • Page of 2
  • Filter
  • Time
  • Show
Clear All
new posts
Previous 1 2 template Next
  • #16
    That rubber piece is NOT an original part of the bike I don't think. The only thing it MIGHT be part of is the original battery hold down bracket.

    Does it have a groove in the outside like it fits and locks into a hole?
    Greg

    Everybody is a genius. But if you judge a fish by its ability to climb a tree, it will live its whole life believing that it is stupid.”

    ― Albert Einstein

    80 SG Ol' Okie;79 engine & carbs w/pods, 45 pilots, 140 mains, Custom Mac 4 into 2 exhaust, ACCT,XS850 final drive,110/90/19 front tire,TKat fork brace, XS750 140 MPH speedometer, Vetter IV fairing, aftermarket hard bags and trunk, LG high back seat, XJ rear shocks.

    The list changes.

    Comment

    • #17
      Looks identical in size and configuration of the tapered sealing rubber under the cap where plug wire attaches to coil off a set of Honda VF coils.
      81H Venturer1100 "The Bentley" (on steroids) 97 Yamaha YZ250(age reducer) 92 Honda ST1100 "Twisty"(touring rocket) Age is relative to the number of seconds counted 'airing' out an 85ft. table-top.

      Comment

      Previous 1 2 template Next
      Working...
      X