If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
found this E-clip on my shed floor this morning, anyone recognize where it might from? quarter sized , looks like it would be external, (bike hasn't been apart) since FD change
where are we going, and why are we in this hand basket?
Iowa the Beautiful Land 1980 XS1100SG
That clip is non-OEM, IMO. It looks like an after-market clip and I've not seen one of that design ever on an original XS1100. I don't think that design of clip was even available in the late 1970's actually. It's external, by the looks of the surface. The wear on the left side looks as if there's not been much lubrication on it.
If it is indeed off your bike, as opposed to being a clip that was just lying around on the floor, then I wonder if it's from the rear brake pivot... you know, the round bar which projects from the frame onto which goes the rear brake lever. The bar has a groove in the end for a clip to go on to......
On my floor, I found four of those clips, three bolts, two stainless washers and a rubber O ring....... none of them from my bike!!!
XS1100F 1980 European model. Standard. Dyna coils. Iridium plugs. XS750 final drive (sometimes). Micron fork brace. Progressive front springs. Geezer regulator/rectifier. Stainless 4 into 2 exhaust. Auto CCT (Venturer 1300) SOLD. New project now on the go. 1980 European model.
If it is quarter sized then I can't remember anywhere that there is one that large. There are some much smaller ones used in the early carbs but that is more like pencil eraser sized.
Nathan
KD9ARL
μολὼν λαβέ
1978 XS1100E K&N Filter
#45 pilot Jet, #137.5 Main Jet
OEM Exhaust
ATK Fork Brace LED Dash lights
Ammeter, Oil Pressure, Oil Temp, and Volt Meters Green Monster Coils SS Brake Lines
Vision 550 Auto Tensioner
In any moment of decision the best thing you can do is the right thing, the next best thing is the wrong thing, and the worst thing you can do is nothing.
been digging thru the parts pdf. all afternoon and didn't see any thing like it, must be a flier from some where else thought maybe off the shift shaft but not the same setup as the xs650, oh well I'll figure out where it goes when something falls off (just hoping it's not me)
where are we going, and why are we in this hand basket?
Iowa the Beautiful Land 1980 XS1100SG
Comment