Anyone near Ft. Benning, GA willing to help with a build?

[Outlaw4shrt]

I do get down to Columbus on occassion since mother-inlaw lives there. would be glad to offer my fab/welding knowledge if needed. Mother inlaw is located bout 2miles from airport in Columbus......JAT.

Any idea when's the next time that you will be in town?

[crazy steve]

[QUOTE=Outlaw4shrt;356863]My issue right now is with trying to repair the wiring harness. It's just been hacked to pieces with leads and grounds from the stock harness that have been cut and left unconnected. Oddly enough, the bike still starts and runs fine the last time I had it together. I've been trying to use the wiring diagram from the clymer manual to figure it out but at this point I am pretty lost. [QUOTE]

The 'big' diagrams in both the Clymer and factory manuals can be confusing... Try looking here to help clarify what you're looking at:

http://www.xs11.com/forum/showthread.php?t=35337

It's also very helpful to look in the unit repair section of either the Clymer or FSM for wire colors/circuitry of the individual systems. It's not as complicated as it can seem, just take your time and be methodical.