Breake HELP!!

[XS1100_OEM4ME]

OK, got my new front pads for my xs1100sf. Go to put them on, one pad is thick at the top the other at the bottom. Follow PO's install, then "I THINK" that might not be a good idea again I am on the right front set, they are installed with the "outside" pad with the "thick at the top", is this correct, and if so, do both sides go with the"outside pad" with the thick at the top pad

[redbone]

if i remember rite....the pads are stamped on the back for left and right side.
after that is established, they can't be installed wrong as the pin that goes thru the pads to keep them from falling out can only go thru one way.

[XS1100_OEM4ME]

Thanks

My new EBC's weren't stamped or marked on the pads or package or came with instructions, nor does the Cylmer man help, BUT, I did do a referance by the part # and determand which was Right and Left, and from there, you are correct, can't put them on wrong

if i remember rite....the pads are stamped on the back for left and right side.
after that is established, they can't be installed wrong as the pin that goes thru the pads to keep them from falling out can only go thru one way.

[TopCatGr58]

Hey there OEM,

Glad you figured out your pads problem. But you still have a problem, and we'd like to direct your attention to this thread for some additional help!

http://www.xs11.com/forum/showthread.php?t=34566

T.C.

[XS1100_OEM4ME]

?

Give me a Brake LOL

Hey there OEM,

Glad you figured out your pads problem. But you still have a problem, and we'd like to direct your attention to this thread for some additional help!

http://www.xs11.com/forum/showthread.php?t=34566

T.C.

[bikerphil]

Oops, this link is broken....try again later.

[mikubuilder]

thanks TC for this much needed lesson