If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
anyone know where i can get some
dual pod filters, ive tried searching ebay
and the net without success.
tia.
pete
new owner of
08 gen2 hayabusa
former owner
1981 xs1100 RH (aus) (5N5)
zrx carbs
18mm float height
145 main jets
38 pilots
slide needle shimmed .5mm washer
fitted with v/stax and uni pod filters
former owner
1981 xs1100 RH (aus) (5N5)
zrx carbs
18mm float height
145 main jets
38 pilots
slide needle shimmed .5mm washer
fitted with v/stax and uni pod filters
link? or pic? 2 pods would look better than 4 imo....cant find them on web eather....is it the squarish looking one? is the spacing correct for the carbs?
_____________________________________________ 1979 XS 1100 Special "The judge" mods- K&N air pods, 4-1 mac, 147.5 pilots, 57.5 mains, LED turn signal, cafe bars, HEL translucent yellow stainless steel brake line, dyna coil (dc2-1), raptor 660 mc, r6 controls..(sold)
link? or pic? 2 pods would look better than 4 imo....cant find them on web eather....is it the squarish looking one? is the spacing correct for the carbs?
Just did a google search and they came up with a list. Here is a few.
1978 XS1100E K&N Filter
#45 pilot Jet, #137.5 Main Jet
OEM Exhaust
ATK Fork Brace LED Dash lights
Ammeter, Oil Pressure, Oil Temp, and Volt Meters Green Monster Coils SS Brake Lines
Vision 550 Auto Tensioner
In any moment of decision the best thing you can do is the right thing, the next best thing is the wrong thing, and the worst thing you can do is nothing.
there should be enuff room, but i havent bought
them so dont know for sure,
i wanted to use these for the zrx carbs i have fitted, (similar spacing)
these have the vent hoses similar to the early model
mikunis,
these filters have a hole for the vent hoses to go into,
so by using these im hoping to get a little bit more oompf
from under 3000rpm.
pete
new owner of
08 gen2 hayabusa
former owner
1981 xs1100 RH (aus) (5N5)
zrx carbs
18mm float height
145 main jets
38 pilots
slide needle shimmed .5mm washer
fitted with v/stax and uni pod filters
T. C. Gresham
81SH "Godzilla" . . .1179cc super-rat.
79SF "The Teacher" . . .basket case! History shows again and again,
How nature points out the folly of men!
thanx for posting TC,
i noticed garry bought a set but havent seen him
post on here for a while, he quoted part number RC3510
i thought it was rc4240, they were exactly the same size
so not to sure what the differences are, also noticed in that
pic it was fitted to the early model carbs, wonder if they attached
the vents to the air intakes?
was about to purchase them, but they dont ship outside the us,
and the one that did ship wanted $150 for shipping.
pete
new owner of
08 gen2 hayabusa
former owner
1981 xs1100 RH (aus) (5N5)
zrx carbs
18mm float height
145 main jets
38 pilots
slide needle shimmed .5mm washer
fitted with v/stax and uni pod filters
Comment