Transmission

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • cuda_phish1
    XSive
    • May 2003
    • 56
    • Indiana, USA

    #1

    Transmission

    I just put a different tank on my '79 XS11 standard till I can get mine sent to be Renu'd in PA. I noticed a line that looks like a vacuum line off the top of my transmission but have no clue where it goes. It is just under the carbs. Any ideas? Oh there is an assembly next to it that resemblies the top of a carb.

    thanks for any help I get gang.
    Cuda
  • Snow
    XS-XJ Guru
    • Oct 2002
    • 1041
    • Tallahassee, FL

    #2
    You may be talking about the oil pressure vent? Not sure exactly the corrent name for that. Does it point towards the right side of the bike? Is the rubber line something like 12-14mm in width? If that is it, then it would connect to your airbox near the top middle.
    1979 XS11F Standard - Maya - 1196cc (out of order)
    1978 XS11E Standard - Nina - 1101cc
    http://www.livejournal.com/~xs11

    Comment

    • cuda_phish1
      XSive
      • May 2003
      • 56
      • Indiana, USA

      #3
      hmmm

      While looking at the directions in removing the air housing i see the same hose sticking up from the back side of it. just where the seat mounts. Not sure if i can put the picture on here off the CD with the manual on it. I'm trying though. GRRR can't get it to transfer over.

      Comment

      • cuda_phish1
        XSive
        • May 2003
        • 56
        • Indiana, USA

        #4
        pressure vent

        Im thinking that may be it after looking in the manual and reading your post. now to find where it connects LOL

        Comment

        • Snow
          XS-XJ Guru
          • Oct 2002
          • 1041
          • Tallahassee, FL

          #5
          This picture is rather busy looking, but the hose is #50 and you can follow the line to the top of the airbox to where it is supposed to mount, doesn't give a good picture of the "nipple" on the airbox...I say nipple has I can't think of a better word right now

          1979 XS11F Standard - Maya - 1196cc (out of order)
          1978 XS11E Standard - Nina - 1101cc
          http://www.livejournal.com/~xs11

          Comment

          • cuda_phish1
            XSive
            • May 2003
            • 56
            • Indiana, USA

            #6
            intake

            Thx Snow. I didn't see that schematic in my manual.

            Comment

            • Geezer
              XS-XJ Guru
              • May 2003
              • 2985
              • Willamina, Oregon 97229

              #7
              The hose you are talking about is a transmission vent tube. It goes over the air box and there is a steel tab over the top air box mount screw that has a U shaped bend in it to hold the tube up.

              BYW, I've always found the air box easier to work with when I tossed the stock screws and replace them with Allen head screws.

              Geezer
              Hi my name is Tony and I'm a bikeoholic.

              The old gray biker ain't what he used to be.

              Comment

              Working...