Tweet
Re: Vacuum Diaphram assembly
Bending the float height tab or tang as you call it will not increase the pressure applied to the float valve. It will only change the fuel level in the bowl and set off a new issue.
Rob
Originally posted by FANNING507
I have overflow problems with #2 carb. I will bend the tang to put more pressure on the needle. Does anyone have a diagram of how the vaccum diaphram is to be assembled? I replaced the flexible diaphram, but fuel is leaking past the control. I think that it was assembled wrong before I got to it, and I replaced it as I found it. There isn't many pieces, but the repair manuel doesn't show the assembly. Kim
I have overflow problems with #2 carb. I will bend the tang to put more pressure on the needle. Does anyone have a diagram of how the vaccum diaphram is to be assembled? I replaced the flexible diaphram, but fuel is leaking past the control. I think that it was assembled wrong before I got to it, and I replaced it as I found it. There isn't many pieces, but the repair manuel doesn't show the assembly. Kim
Rob
"
Comment