Tweet
That single fuse holder is what is referred to in the Clymer manual's wiring diagram as the terminal assembly. It is a circuit for add on electrical components, separate from the fuse panel, and won't interfere with the swapping fuse boxes.
-
-
I still don't have a photo yet. SorryUnited States Merchant Marine Academy, Kings Point, NY
If I can do it at 18 yrs old, anyone can
"You know something, You can't polish a turd"
"What are you rebelling against", "Well, what do you got?"
Acta Non VerbaComment
-
Hey Dodjh,
I ran the Positive that normaly went to the fuse there with the terminal screws up and over to the fuse block, then ran another line from the other side of the fuse block to the terminal connector. The ground is just run like it is to ground. So...just bypass the glass fuse holder clips and run it thru one of the fuseblock slots!
T.C.T. C. Gresham
81SH "Godzilla" . . .1179cc super-rat.
79SF "The Teacher" . . .basket case!
History shows again and again,
How nature points out the folly of men!Comment
Comment