OK I did not remove the generator from the Left hand side of the crank when I split my cases but I can see now that the cases have a lip that slips under the generator and it is making reassembly difficult because I can not drop the bottom half straight down onto the top half. I do not have the Yamaha tool for removal of the generator but do have a puller. I have not however been able to get that bugger off. I have tighten the puller up very tight and taped on the end ... no luck. I have done it with heat put to the generator while under puller tension and still no luck. I was using a propane plumbers torch as the heat source and I wonder .. is that enough heat? I do have a papane torch. Should I use that and REALLY heat the generator up while under puller tension? I really need to get this puppy off there to proceed with the work.
Rob
Rob
Comment