New Member introduction
Collapse
X
-
Nathan
KD9ARL
μολὼν λαβέ
1978 XS1100E
K&N Filter
#45 pilot Jet, #137.5 Main Jet
OEM Exhaust
ATK Fork Brace
LED Dash lights
Ammeter, Oil Pressure, Oil Temp, and Volt Meters
Green Monster Coils
SS Brake Lines
Vision 550 Auto Tensioner
In any moment of decision the best thing you can do is the right thing, the next best thing is the wrong thing, and the worst thing you can do is nothing.
Theodore Roosevelt -
Greg
Everybody is a genius. But if you judge a fish by its ability to climb a tree, it will live its whole life believing that it is stupid.”
― Albert Einstein
80 SG Ol' Okie;79 engine & carbs w/pods, 45 pilots, 140 mains, Custom Mac 4 into 2 exhaust, ACCT,XS850 final drive,110/90/19 front tire,TKat fork brace, XS750 140 MPH speedometer, Vetter IV fairing, aftermarket hard bags and trunk, LG high back seat, XJ rear shocks.
The list changes.Comment
-
Comment
-
Hey again,
What hasn't been told to you is that the CLUNKING into 1st is part of the wear that the dogs/slots get that can eventually lead to the dredded 1st and 2nd gear skip/failure. So..the techniques mentioned to reduce the clunk are also in helping to reduce the wear on the gears dogs/slots. See the tech tips/ repairs/ transmission for info about this malady and the work involved in fixing it.
The gears are not synchromesh type, and so you can cause damage to the dogs/slots when trying to shift without using the clutch IF you miss the rpm match and end up grinding them a bit, so that's why we don't really recommend shifting without the clutch, but knowing you could is helpful for that "IN CASE" where the clutch cable breaks!
T.C.T. C. Gresham
81SH "Godzilla" . . .1179cc super-rat.
79SF "The Teacher" . . .basket case!
History shows again and again,
How nature points out the folly of men!Comment
-
Thanks all! I just upgraded from a Honda CB400 and let me tell you... I am VERY happy I did. Can't wait to get the fairing off and feel the wind on my chest instead of just my head (I'm 6'4" so the windshield is juuuuust a little short) hoping to find wiring and headlight replacement ideas here.
As for CL, I bet you did. I picked it up in Joliet. It's gonna live in Chicago with me for what I hope will be a long time.
81H Venturer
past bikes
1990 Suzuki VX800
1972 Honda CL350 Scrambler
1995 BMW K75SAComment
-
Good, then you're both close enough to make the rally in Michigan in August.
I'll most likely be there.Greg
Everybody is a genius. But if you judge a fish by its ability to climb a tree, it will live its whole life believing that it is stupid.”
― Albert Einstein
80 SG Ol' Okie;79 engine & carbs w/pods, 45 pilots, 140 mains, Custom Mac 4 into 2 exhaust, ACCT,XS850 final drive,110/90/19 front tire,TKat fork brace, XS750 140 MPH speedometer, Vetter IV fairing, aftermarket hard bags and trunk, LG high back seat, XJ rear shocks.
The list changes.Comment
-
Good, then you're both close enough to make the rally in Michigan in August.
I'll most likely be there.81H Venturer
past bikes
1990 Suzuki VX800
1972 Honda CL350 Scrambler
1995 BMW K75SAComment
-
ah nice! Yeah, I lived in Pilsen for 3 1/2 years, then moved to Logan, now living in Bucktown. We ought to meet up for a ride sometime.81H Venturer
past bikes
1990 Suzuki VX800
1972 Honda CL350 Scrambler
1995 BMW K75SAComment
-
Are you here as well?81H Venturer
past bikes
1990 Suzuki VX800
1972 Honda CL350 Scrambler
1995 BMW K75SAComment
Comment