If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
does anyone out there know what the gap between the pick up coils and the roter are supposed to be on a 79 special? also what is the corect way to mesure it?
any help would be great!!
thanks!
Tony, I have never seen it written anywhere but when I did mine I used; .004" to .006". And it worked fine. I used a brass feeler guage that I had laying around from an old English car tool kit.
I would think the closer the better as long as they do not have any physical contact.
Hope this helps. Maybe someone out there has found it written down and give you the "Official" setting.
Ken/Sooke
78E Ratbyk
82 FT500 "lilRat"
I ran into the same thing quite a while back.The information I got was .020 gap between the relutor to pickup coil gap.Hard to gap but I have it set as close as I can and not touch.Hope this helps.
I posted a lengthy article from Meriam Cycles regarding this a while back but can't find the post now. Setting the gap as close as possible without touching is best. Recommend .004 to .006 as suggested before. They (Meriam cycles) said they had cured several problems from not starting to poor running with this fix.
Sorry I couldn't find the article. HTH
Unless you are the lead sled dog the view never changes.
Comment