Tweet
Putting new clocks on, can someone tell me which wire is which please, ie tacho feed and light? Wiring is the bain of my life and not good with diagrams
-
79SF
xjr ohlins shocks, tarozzi forkbrace, bsa handlebars, bsm exhaust -
White should be the signal feed and tan should be the bulbs. Black is ground.Last edited by bikerphil; 09-28-2015, 07:24 AM.2H7 (79) owned since '89
3H3 owned since '06
"If it ain't broke, modify it"
☮ -
Rob, if you are using an aftermarket tach, you can't use the signal wire for the XS tach, it is an AC voltage from the alternator. Conventional tach hookup would be the neg. side of the ignition coil.2H7 (79) owned since '89
3H3 owned since '06
"If it ain't broke, modify it"
☮Comment
-
Thanks for the info guys79SF
xjr ohlins shocks, tarozzi forkbrace, bsa handlebars, bsm exhaustComment
-
If you are using aftermarket gauges, it should also be noted that almost all aftermarket cable-drive speedos use a 2:1 ratio at the speedometer drive. The XS uses a 2.9:1 ratio, so that would make a 2:1 speedo read about 1/3 fast...Fast, Cheap, Reliable... Pick any two
'78E original owner - resto project
'78E ???? owner - Modder project FJ forks, 4-piston calipers F/R, 160/80-16 rear tire
'82 XJ rebuild project
'80SG restified, red SOLD
'79F parts...
'81H more parts...
Other current bikes:
'93 XL1200 Anniversary Sportster 85RWHP
'86 XL883/1200 Chopper
'82 XL1000 w/1450cc Buell, Baker 6-speed, in-progress project
Cage: '13 Mustang GT/CS with a few 'custom' touches
Yep, can't leave nuthin' alone...Comment
.
Comment