.... and yesterday, while on the job, I took some radio repeaters to a guy to get fixed. While waiting, I attempted to strike up a conversation. I noticed a big Harley banner in his workshop and asked him if he rode. He said he did, and had 3 bikes in the back. I said, "when you are done with the radios, perhaps you can show me your bikes."
I then told him I rode a 79 Yamaha. He said, "oh." Then the conversation went dead so I just sat there and waited. When he was finished with the radios, he said, "ok, thanks, we'll see you later." I said, "can we look at your bikes?" He took me back in the back long enough to lift the tarp off of one fender to show me just the fender of one.
I could see the other two and attempted to talk to him about the engine design, etc. I asked him how much compression a stock Harley made and he said, "I have no idea." That seemed a little odd to me considering that he told me earlier that he worked on them and mods them for horsepower, etc.
I found out he let a bike shop in CA put on new pipes and fuel injection remap for him. He showed me a dyno sheet. His "dyno" bike had the 88 C.I. engine on it and, with a new set of pipes and fuel remap, he was making about 70hp and 80lb of torque.
Anyway, with that, he seemed too busy to chat about much else, so I left.
He did get one thing very right, though. He said, "Harley's never were made for performance." I wanted to say, "yep, but what were they made for, then?" I didn't want to tell him how much HP and torque a new, stock XS11 made.
I couldn't help but think how much money he had tied up in those three bikes, and how little he was able to get to them for riding.
Nice guy when it came to radios, though, and he did a good job with them.
Interesting day.
Ben
I then told him I rode a 79 Yamaha. He said, "oh." Then the conversation went dead so I just sat there and waited. When he was finished with the radios, he said, "ok, thanks, we'll see you later." I said, "can we look at your bikes?" He took me back in the back long enough to lift the tarp off of one fender to show me just the fender of one.
I could see the other two and attempted to talk to him about the engine design, etc. I asked him how much compression a stock Harley made and he said, "I have no idea." That seemed a little odd to me considering that he told me earlier that he worked on them and mods them for horsepower, etc.
I found out he let a bike shop in CA put on new pipes and fuel injection remap for him. He showed me a dyno sheet. His "dyno" bike had the 88 C.I. engine on it and, with a new set of pipes and fuel remap, he was making about 70hp and 80lb of torque.
Anyway, with that, he seemed too busy to chat about much else, so I left.
He did get one thing very right, though. He said, "Harley's never were made for performance." I wanted to say, "yep, but what were they made for, then?" I didn't want to tell him how much HP and torque a new, stock XS11 made.
I couldn't help but think how much money he had tied up in those three bikes, and how little he was able to get to them for riding.
Nice guy when it came to radios, though, and he did a good job with them.
Interesting day.
Ben
Comment