Paint Codes please

Collapse
X
 
  • Time
  • Show
Clear All
new posts

  • MPittma100
    replied
    Paint

    Of the 2 1980 colors that I had mixed, one (New Ruby Red) was done simply by the make and model year of the bike. The other color (Diamond Silver) had to be matched by the body shop's paint rep who used their "magic" machine to photograph the color and determine the mixing recipe from that.

    Both colors were a perfect match. They were base coat/clear coat applications. Duplicate decals for saddle bags are available from KZ900.com

    MP
    Last edited by MPittma100; 05-01-2014, 05:52 PM.

    Leave a comment:


  • motoman
    replied
    BTW, interesting that IndigoBlue for majority of folks is not even close to what Mother Yammy calls indigo blue.

    Leave a comment:


  • motoman
    replied
    Originally posted by DiverRay
    If you have the old tank, and want a match, take it to a shop and have them match the BOTTOM of the tank. The overspray in the tunnel will help get a match you can trust. I know the top and sides are faded, but the underside NEVER gets daylight on it.
    +1, that was how mine was matched.
    MarkD's issue may be the fact that blue is a bit different shade on each of the three yr. Standards. I can tell you for sure(and some may verify that have seen), that color code/name is a dead-on match for the 81H, which BTW was the only color the Venturer came as. The sidecovers repainted, cannot even be depicted they were ever re-done as the paint 'layed' perfectly flat and shiney. 3-4 coats between 'flash' drying, plus I did that some years back in garage, in Feb., and only 55-60degrees in there. The dryer climate/air here I'm sure benefited the results some.

    Leave a comment:


  • DiverRay
    replied
    If you have the old tank, and want a match, take it to a shop and have them match the BOTTOM of the tank. The overspray in the tunnel will help get a match you can trust. I know the top and sides are faded, but the underside NEVER gets daylight on it.

    Leave a comment:


  • MPittma100
    replied
    Paint

    I earlier posted the two 1980 colors. I had them professionally mixed at a body shop. Not the cheapest way to get paint matched, but it appears to be the surest way and best match.

    I will eventually need the 1979 Indigo blue as well.

    Mike

    Leave a comment:


  • MarkD
    replied
    OK-- Not a good match on the Carbon Blue-Black-effect... 2000 Toyota, code210. Ended up that it was too far off color match, especially for a job more than a scratch filler. Will now order YAMAHA 004E INDIGO BLUE by color-rite.

    http://www.amazon.com/ColorRite-YAMA.../dp/B00BSGGWX4

    Pretty small area on rear cowl to treat. Should be all-good.

    Leave a comment:


  • RichV
    replied
    Originally posted by Schming
    I've gotta ask why you guys are gambling with mail order colors and not taking your parts to an automotive paint supplier which will computer match any color ?

    Also they'll most likely be able to give expert advice on products and application.
    I agree that a paint match is the best way to go for touch-ups. However, I have a bike with four layers of paint on it and I can't trust the base layer to still have the right shade of red. This is why on a previous thread I was asking if anyone had a source for a match.

    There's also the problem with age. Most of the paints from the late 70s to early 80s where not the best for maintaining color. Since I have to paint the whole thing anyway, I'm looking to recreate the original shade and depth only with a modern paint.

    Leave a comment:


  • RichV
    replied
    Originally posted by crazy steve
    Make sure you can actually import the paint; some chemicals available outside the US can't be brought into it....
    It's legal to import the paint as long as the quantities are low. Usually the amount to paint a tank and side panels is well below the limit. It takes a week for them to get to a US address.

    Leave a comment:


  • MPittma100
    replied
    Yamaha Paint Codes

    Pick One:

    Leave a comment:


  • MarkD
    replied
    I ended up with the small container of code 210 as I only have a couple of small deep scratches on my rear cowl ( from a rack PO had carelessly put on and taken off a time or two). The scratches are clean and thin and sort of deep, and only need a small amount of paint to more or less fill the marks. Upshot is, not enough surface to worry about, and the spot is very inconspicuous.

    Leave a comment:


  • Schming
    replied
    I've gotta ask why you guys are gambling with mail order colors and not taking your parts to an automotive paint supplier which will computer match any color ?

    Also they'll most likely be able to give expert advice on products and application.

    Leave a comment:


  • MarkD
    replied
    I just got my paint in the mail .

    Carbon Blue-Black-effect... 2000 Toyota, code210

    I hope it's match, will let you know when the painting happens.

    Leave a comment:


  • crazy steve
    replied
    Make sure you can actually import the paint; some chemicals available outside the US can't be brought into it....

    Leave a comment:


  • RichV
    replied
    I found this site:


    Which is in UK that claims to be able to mix all the Yamaha colorcodes. This includes Cardinal Red (CDR) which has been very difficult to find.

    I don't know if this can be used as a reference or not but it seems to provide a uniform source for the paints. I know nothing about the quality but I will probably buy from them unless I find a better source.

    Leave a comment:


  • mack
    replied
    Paint

    I will be seeing my guy on the weekend and will talk to him about the powder coat formulas. I know what Steve is talking about. I wanted to go back to Macho Maroon for my 78 but no one could match it. I've selected a different colour all together now. It's called "Madagascar Gold" and I'll use black pin stripping on it. Looked dull in side and on a cloudy day but pops in the sunlight. Not sure if I like it yet but it is what it is. I had a fairing and hard bags done with it so , it is what it is.

    Leave a comment:

Working...