Tweet
Does anyone know what type of epoxy/glue I can use to glue the brass fuel line tubes back into the petcock housing?
-
1979 XS1100SF with a Jardine 4 into 1, ZRX 1200 carbs, 82 XJ rear air shocks, ACCT
SOLD - 1980 XS1100SG with a Mac 4 into 1, ZRX 1200 carbs, round 160 speedo, 82 XJ rear air shocks, ACCT -
They should be a press fit, try lightly tapping them in with a hammer and they should stay.2H7 (79) owned since '89
3H3 owned since '06
"If it ain't broke, modify it"
☮ -
From http://www.jbweld.com/faqs/Originally posted by vanimal5k View Post
"Is J-B Weld resistant to water and/or gasoline?
When fully cured, J-B Weld is completely resistant to water, gasoline, and about every other petroleum product or automotive chemical. For wet-surface or submerged water or gasoline repairs, try our SteelStik or WaterWeld.Comment
-
Hi Van and welcome,Originally posted by vanimal5k View Post
try tinning them.
Bernz torch, resin flux, any kind of solder.
Wipe the excess off with a rag so there's only a thin coating.
Press back into place.Fred Hill, S'toon
XS11SG with Spirit of America sidecar
"The Flying Pumpkin"Comment
-
Hi Fred, thanks for the welcome. Sounds like a good idea. Hopefully this will stop the gas leaks. Thanks for the reply!!!!!!1979 XS1100SF with a Jardine 4 into 1, ZRX 1200 carbs, 82 XJ rear air shocks, ACCT
SOLD - 1980 XS1100SG with a Mac 4 into 1, ZRX 1200 carbs, round 160 speedo, 82 XJ rear air shocks, ACCTComment
Comment