I am looking for the small tubes that run between the carbs. Does anyone know where I can order them or does anyone have any laying around?
Announcement
Collapse
No announcement yet.
where to order carb parts
Collapse
X
-
I looked and could not find any. I did come across someone that had done a DIY version but can't remember where. You may have to dig a bit.81H Venture - hope to ride summer 2013
79F Cafe Racer at Some Point;
68 CB175 Sloper - Cafe Racer
74 KZ400 - Restoration project nightmare
62 BSA Super Rocket - In Pieces
72 CB100 Super Sport - Not super or sporty but fun
-
Are you needing the fuel t's that go between the 1-2 and 3-4 carbs?Jason
Montgomery, AL
80 XS1100SG Daily Driver
81 XS1100SH (Getting ready for an engine rebuild)
86 Honda Magna V45 (sold)
Comment
-
I just saw some fuel T's somewhere on a site today but can't remember where. Replacements are brass and pretty pricey.Greg
Everybody is a genius. But if you judge a fish by its ability to climb a tree, it will live its whole life believing that it is stupid.”
― Albert Einstein
80 SG Ol' Okie;79 engine & carbs w/pods, 45 pilots, 140 mains, Custom Mac 4 into 2 exhaust, ACCT,XS850 final drive,110/90/19 front tire,TKat fork brace, XS750 140 MPH speedometer, Vetter IV fairing, aftermarket hard bags and trunk, LG high back seat, XJ rear shocks.
The list changes.
Comment
-
2H7 (79) owned since '89
3H3 owned since '06
"If it ain't broke, modify it"
☮
Comment
-
2H7 (79) owned since '89
3H3 owned since '06
"If it ain't broke, modify it"
☮
Comment
-
The tee fitting on my XS650 failed recently. A brass replacement is $70! I bought some cheap clear fuel line from the hardware store. I stripped the old plastic off the ends of the old tee and put short pieces of clear tubing in its place. It substitutes for the stack of o'rings in bikerphil's fix. I had to use a bar clamp to fit the tee between the clamps. It does not leak.Marty (in Mississippi)
XS1100SG
XS650SK
XS650SH
XS650G
XS6502F
XS650E
Comment
Comment