Top End Job

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • 80mdnt11
    XStremely XSive
    • Mar 2006
    • 221
    • S.E. IL./ Olney

    #1

    Top End Job

    Looking for 0.50 over piston set. '80 XS1100LG Any suggestions where to start looking? All bores tapered .002-.0025, thinking 0.50 should clean up ok.
    Thanks
    "Elvira"
    '80 XS1100LG
  • natemoen
    Master of XSology
    • May 2010
    • 8640
    • Fargo

    #2
    Get a different set of just and pistons. You will probably never find 4 .5 over pistons.
    Nathan
    KD9ARL

    μολὼν λαβέ

    1978 XS1100E
    K&N Filter
    #45 pilot Jet, #137.5 Main Jet
    OEM Exhaust
    ATK Fork Brace
    LED Dash lights
    Ammeter, Oil Pressure, Oil Temp, and Volt Meters

    Green Monster Coils
    SS Brake Lines
    Vision 550 Auto Tensioner

    In any moment of decision the best thing you can do is the right thing, the next best thing is the wrong thing, and the worst thing you can do is nothing.

    Theodore Roosevelt

    Comment

    • BA80
      Doctor of XSology
      • Oct 2010
      • 9980
      • Tulsa, Ok

      #3
      Greg

      Everybody is a genius. But if you judge a fish by its ability to climb a tree, it will live its whole life believing that it is stupid.”

      ― Albert Einstein

      80 SG Ol' Okie;79 engine & carbs w/pods, 45 pilots, 140 mains, Custom Mac 4 into 2 exhaust, ACCT,XS850 final drive,110/90/19 front tire,TKat fork brace, XS750 140 MPH speedometer, Vetter IV fairing, aftermarket hard bags and trunk, LG high back seat, XJ rear shocks.

      The list changes.

      Comment

      • 80mdnt11
        XStremely XSive
        • Mar 2006
        • 221
        • S.E. IL./ Olney

        #4
        Seen the big bore kit............going 3mm seems a bit much. From 71.5 to 74.5mm would thin sleeves and skirts. Anyone try one on here? figured would be needle in hay stack to find four .5, love a challenge!
        "Elvira"
        '80 XS1100LG

        Comment

        • BA80
          Doctor of XSology
          • Oct 2010
          • 9980
          • Tulsa, Ok

          #5
          They are getting pretty scarce. These popped up on ebay a while back at a VERY affordable price. I'm thinking of getting one just to have around.

          I don't think you'll find much else.
          Greg

          Everybody is a genius. But if you judge a fish by its ability to climb a tree, it will live its whole life believing that it is stupid.”

          ― Albert Einstein

          80 SG Ol' Okie;79 engine & carbs w/pods, 45 pilots, 140 mains, Custom Mac 4 into 2 exhaust, ACCT,XS850 final drive,110/90/19 front tire,TKat fork brace, XS750 140 MPH speedometer, Vetter IV fairing, aftermarket hard bags and trunk, LG high back seat, XJ rear shocks.

          The list changes.

          Comment

          • 80mdnt11
            XStremely XSive
            • Mar 2006
            • 221
            • S.E. IL./ Olney

            #6
            Hum, Yea was thinking same. 150.00 on kit is darn good price! Just little learry. Not so much on the e-bay, one shot and done!
            "Elvira"
            '80 XS1100LG

            Comment

            • BA80
              Doctor of XSology
              • Oct 2010
              • 9980
              • Tulsa, Ok

              #7
              I have a friend that bought one for his ailing MNS and said the parts all look to be better than fair quality. He hasn't done the work yet so I can't say more than that.

              If your worried about thinning tha cyl walls and overheating problems I CAN say that I know some personally with the same overbore Wiseco kits ($800) that are experincing no significant problems at all in that area.

              If you worrying about ruining a set of jugs, I have 8 more sets laying on my garage floor. No worries there.
              Greg

              Everybody is a genius. But if you judge a fish by its ability to climb a tree, it will live its whole life believing that it is stupid.”

              ― Albert Einstein

              80 SG Ol' Okie;79 engine & carbs w/pods, 45 pilots, 140 mains, Custom Mac 4 into 2 exhaust, ACCT,XS850 final drive,110/90/19 front tire,TKat fork brace, XS750 140 MPH speedometer, Vetter IV fairing, aftermarket hard bags and trunk, LG high back seat, XJ rear shocks.

              The list changes.

              Comment

              Working...