Announcement

Collapse
No announcement yet.

Crank Bearings

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    Crank Bearings

    I have the motor from the E apart and since it is, I figured I might as well put new crank bearings in it. Haven't been able to find any so far. Is there a source for these.
    If not, I have three old sets I could canablize. What to look for in ruling out the prospective candidates.
    As a side note, is Geezer back into making the regulator/rec upgrade?
    mack
    79 XS 1100 SF Special
    HERMES
    original owner
    http://i946.photobucket.com/albums/a...ps6932d5df.jpg

    81 XS 1100 LH MNS
    SPICA
    http://i946.photobucket.com/albums/ad305/mack-055/2.jpg

    78 XS 11E
    IOTA
    https://youtu.be/wB5Jfbp6SUc
    https://youtu.be/RaI3WYHSuWA



    Have recovery trailer and shop if you breakdown in my area.
    Frankford, Ont, Canada
    613-398-6186
    Tags: None
  • #2
    This is a very timely post as I have been in discussions with another member about my NOS set of BLUE mains for sale...see this thread

    http://www.xs11.com/forum/showthread.php?t=38969
    Former owner, but I have NO PARTS LEFT!

    Comment

    • #3
      There are some on fleabay mack....

      http://motors.shop.ebay.com/i.html?_...506.m270.l1313
      Greg

      Everybody is a genius. But if you judge a fish by its ability to climb a tree, it will live its whole life believing that it is stupid.”

      ― Albert Einstein

      80 SG Ol' Okie;79 engine & carbs w/pods, 45 pilots, 140 mains, Custom Mac 4 into 2 exhaust, ACCT,XS850 final drive,110/90/19 front tire,TKat fork brace, XS750 140 MPH speedometer, Vetter IV fairing, aftermarket hard bags and trunk, LG high back seat, XJ rear shocks.

      The list changes.

      Comment

      • #4
        I'm going through this as well. If you want to know what bearings were installed in your bike from the factory you have to do a little math. Check Davinci's link in this post to see what to do. Besides that, you may need to go to a thicker bearing depending on how worn yours are.
        "The Hooligan" XJ1100, Virago Gauge Pods, Screaming Eagle Mufflers, K&N Filter, hand made rear fender, side covers, and solo seat, round bar conversion, small headlight, tail light, and cat eye turn signals, chip fuses, rewired the right way.

        Pics: http://s1236.photobucket.com/user/ya...?sort=6&page=1

        Comment

        Previous template Next
        Working...
        X