Metal Valve Stems for Tubeless Tires

[tv5150]

Anyone know off-hand either what the exact hole size is for the valve stems on tubeless rims OR a direct replacemant that doesn't require any drilling or reaming-out the stock hole??? Them smallest diameter available at NAPA is just a tad too big and I thought maybe someone here would know a good source to get one from...
Thanks for any help in this..TV

[bikerphil]

I've got them before from Dennis Kirk, it is listed in the catalogue as for rims with an 8.4 MM hole. You should be able to find one at a bike shop that mounts tires.

[WSL91]

I've installed 3 of these this summer and they fit as they should

http://www.bikebandit.com/camel-tube...ire-valve-stem

[tv5150]

Thanks!!!

I found the OEM stock Part # 93900-00001-00
and ordered 3 from Honda East Toledo
where I buy all my stock parts for all
of my bikes, been dealing with them for
like 5 yrs and they always do me right.
Got three for $5.44 each...
I live in a one-horse town (AND it's half-dead)
Much more cost efffective to buy on-line
or by phone instead a driving 100+ miles
for a $6 part....
But, thanks for all the replies...;

[MaximPhil]

Hi tv5150,
Before you install that valve stem. Clean the "landing area" with
a bit of fine snadpaper. It took me 3 months to figure out that was where my leak was
Phil