Seat ID?

[greatnw]

This seat was sitting on my 80 SG when I picked it up. Not close, but hoping someone might have an idea what it does fit!

It is a Rich's seat which I believe is a local guy doing custom seat rebuilds here in WA.

Thanks.

By rcinkovich at 2011-10-29

By rcinkovich at 2011-10-29

By rcinkovich at 2011-10-29

By rcinkovich at 2011-10-29

[CaptonZap]

Seat ID

If the pan is made of plastic, then it looks like the one on an 82 Maxim 1100. The hooks fit in latches that are welded to the frame. The foam fillers are just what long legged riders need to make it fit better. CZ

[XS1100 Newbie]

That's to bad it is not a bolt on for you. Rich's seats are expensive, but made very well. You have to go spend the night for a day or two in his rooms, to allow for the custom fit. I think they start at about $700.00.

[greatnw]

Thanks guys,

It is a plastic pan and is in good shape except for a torn area on the bottom edge. I would just put some tape on it if I was going to use it since it isn't really visible.

I am a long legged rider and anything for more room is good.