Tweet
This looks a bit pricey but I was wondering if it would fit our bikes? 6mm threaded end.....
http://cgi.ebay.co.uk/Kawasaki-Z1-Z9...item19c64c13ab
http://cgi.ebay.co.uk/Kawasaki-Z1-Z9...item19c64c13ab
-
XS1100F 1980 European model. Standard. Dyna coils. Iridium plugs. XS750 final drive (sometimes). Micron fork brace. Progressive front springs. Geezer regulator/rectifier. Stainless 4 into 2 exhaust. Auto CCT (Venturer 1300) SOLD. New project now on the go. 1980 European model. -
I actually made one of those from a brass fitting and a piece of clear tubing.Greg
Everybody is a genius. But if you judge a fish by its ability to climb a tree, it will live its whole life believing that it is stupid.”
― Albert Einstein
80 SG Ol' Okie;79 engine & carbs w/pods, 45 pilots, 140 mains, Custom Mac 4 into 2 exhaust, ACCT,XS850 final drive,110/90/19 front tire,TKat fork brace, XS750 140 MPH speedometer, Vetter IV fairing, aftermarket hard bags and trunk, LG high back seat, XJ rear shocks.
The list changes.
-
I think at that price, I'll do the same myself! What sort of fitting did you use?Originally posted by BA80 View PostXS1100F 1980 European model. Standard. Dyna coils. Iridium plugs. XS750 final drive (sometimes). Micron fork brace. Progressive front springs. Geezer regulator/rectifier. Stainless 4 into 2 exhaust. Auto CCT (Venturer 1300) SOLD. New project now on the go. 1980 European model.Comment
-
Drill out the internals of a grease zerk that has the correct threads and you have the same thing for just a few cents.Nathan
KD9ARL
μολὼν λαβέ
1978 XS1100E
K&N Filter
#45 pilot Jet, #137.5 Main Jet
OEM Exhaust
ATK Fork Brace
LED Dash lights
Ammeter, Oil Pressure, Oil Temp, and Volt Meters
Green Monster Coils
SS Brake Lines
Vision 550 Auto Tensioner
In any moment of decision the best thing you can do is the right thing, the next best thing is the wrong thing, and the worst thing you can do is nothing.
Theodore RooseveltComment
-
8mm x 1.0mm 91-97 Ford Escort brake bleeder screw will work, no drilling necessary. Wrap some Teflon tape around the threads to seal it.
LarryInventor of the YICS Eliminator. Want one? Get it here.
http://www.xs11.com/forum/showthread...399#post183399
If you're not riding, you're not living!
82 XJ1100
80 XS1100G (Project bike)
64 Yamaha YA-6
77 Suzuki TS-185
79 XS1100SF Built this one for a friend.
See it here... http://www.youtube.com/watch?v=cBYT4C9_6AcComment
Comment