Announcement

Collapse
No announcement yet.

FD conversion questions

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
  • #1

    FD conversion questions

    Preparing to do the conversion.
    Mocking up my swap in rear end and I have several questions.

    1) In this conversion you do use the ws1100 driveshaft?


    2) XS 850 yokes are different? I havent looked at an 850 yoke but I have the
    1100 and when I insert the shaft it is recessed up in there at least 1/2 inch.
    Thanks,
    George
    1980 XS1100 special
    4 to 1 Kerker exhaust
    120 mph speedo.
    1979 carbs jetted 147 mains
    47 idle

    1980 XJ 650
    Tags: None
  • #2
    Yes, you use the XS1100 drive shaft. The XS750/850 drive shaft is to long for the XS1100 swing arm.
    Life is what happens while your planning everything else!

    When your work speaks for itself, don't interrupt.

    81 XS1100 Special - Humpty Dumpty
    80 XS1100 Special - Project Resurrection


    Previously owned
    93 GSX600F
    80 XS1100 Special - Ruby
    81 XS1100 Special
    81 CB750 C
    80 CB750 C
    78 XS750

    Comment

    • #3
      use 11oo shaft

      So I guess the shaft I have in my hand must be the long one. I was looking at it with the bushing, then inserting it into the yoke I have and it didn't make a lot of sense.
      Thanks
      1980 XS1100 special
      4 to 1 Kerker exhaust
      120 mph speedo.
      1979 carbs jetted 147 mains
      47 idle

      1980 XJ 650

      Comment

      Previous template Next
      Working...
      X