Tweet
My sending unit gasket has disintegrated and the shop I had clean and coat my tank made a innertube gasket that doesnt look like it will seal.
What do I use to make a decent one?
What do I use to make a decent one?
-
79 Special
2012 FJR1300
78 E (project. Clutch problems from PO) Must sell -
Get some gas resistant gasket paper and make one. Ace hardware usually has a few options for gasket paper.Nathan
KD9ARL
μολὼν λαβέ
1978 XS1100E
K&N Filter
#45 pilot Jet, #137.5 Main Jet
OEM Exhaust
ATK Fork Brace
LED Dash lights
Ammeter, Oil Pressure, Oil Temp, and Volt Meters
Green Monster Coils
SS Brake Lines
Vision 550 Auto Tensioner
In any moment of decision the best thing you can do is the right thing, the next best thing is the wrong thing, and the worst thing you can do is nothing.
Theodore Roosevelt -
Yamaha P/N 2H7-85753-00-00, about $7. Don't mess around when it comes to a situation that could cause a fire, JMHO.2H7 (79) owned since '89
3H3 owned since '06
"If it ain't broke, modify it"
☮Comment
-
+1 bikerphil! There's a time to go on the cheap.........that's NOT one of them!81H Venturer1100 "The Bentley" (on steroids) 97 Yamaha YZ250(age reducer) 92 Honda ST1100 "Twisty"(touring rocket) Age is relative to the number of seconds counted 'airing' out an 85ft. table-top.Comment
-
Ok. part paid for. I should see it in a week.
Thanks for keeping me straight on this.79 Special
2012 FJR1300
78 E (project. Clutch problems from PO) Must sellComment
Comment