Tweet
what is the proper way to test the pick up coils. My understanding is that they should read 720 ohms but im only getting ( .736 kil ohms ) and this is testing them off the bike
-
-
if you are getting .736 kilo ohm then that would be the same as 736 ohm. Your meter is reading on the 1000 scale so it is reading in kilo (metric for 1000) ohm.Nathan
KD9ARL
μολὼν λαβέ
1978 XS1100E
K&N Filter
#45 pilot Jet, #137.5 Main Jet
OEM Exhaust
ATK Fork Brace
LED Dash lights
Ammeter, Oil Pressure, Oil Temp, and Volt Meters
Green Monster Coils
SS Brake Lines
Vision 550 Auto Tensioner
In any moment of decision the best thing you can do is the right thing, the next best thing is the wrong thing, and the worst thing you can do is nothing.
Theodore Roosevelt -
P/U coil wire test
If you want to test those wires, it isn't that hard. Unplug the small connector at the TCI, and check these pairs of wires with an ohm meter.
wht/red + wht/grn
yel/grn + yel/red
They should read 720 ohm + or - 20%.
Wiggle the wires under the ign. cover (key off) while you are checking the readings.
Any breaks should show up by a faulty fluctuating reading.
Edit: With them off the bike, test the same way.2H7 (79)
3H3
"If it ain't broke, modify it"
☮Comment
-
The p/u coils
are rarely the problem, it is the wires that have to flex in operation that fail. A static test will not give conclusive results unless the wires are manipulated when testing .79SF
XJ11
78EComment
Comment