Announcement

Collapse
No announcement yet.

What's the plan for parts...

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • What's the plan for parts...

    Hey all,

    Had some great help from the forum on a couple things on my new to me 80 XS SG Special.

    One thing I did not anticipate enough was the lack of certain parts (left side rear wheel bearings, and seal for that bearing) for these bikes. I have done searches and gone through many threads looking for ideas and alternate parts for these bikes.

    Is there a guru out there that has stocked up on parts like this as things became scarce but before they were discontinued?

    I pulled the rear end to get a look at the bearings and service things. I popped out the right side bearing, dinging it in the process and luckily I had the sense to leave the left side the heck alone. So, I have a right bearing and seal coming from BikeBandit (local bearing shop wanted $25 for this bearing and had no seal so forget that...) What I did notice was some heat signs on the outer rim of the bearing, brown discoloration of the metal. So I would have wanted to replace it anyway, unless the heat signs are not a problem.

    I cleaned off the left side bearing and re packed it so-to-speak by mashing in new grease with the bearing still in the wheel, no way I'm going to take it out unless I have a replacement.

    SO, anyone out there have a bearing to spare as well as a seal they'd be able to part with for the proper fee?

    The bearing shows no signs of any problems, so I'm not losing any sleep over leaving it in, just like to have one on hand if I ever have a problem.

    Thanks in advance!!
    Howard

    ZRX1200

    BTW, ZRX carbs have the same spacing as the XS11... http://www.xs11.com/forum/showthread.php?t=35462

  • #2
    This might help....

    http://www.xs11.com/forum/showthread...threadid=17293
    Ernie
    79XS1100SF (no longer naked, now a bagger)
    (Improving with age, the bike that is)

    Comment


    • #3
      Thanks for the reply.

      I did see that thread and before I went that route, wanted to see if anyone has some they stocked up on that would be willing to part with one.
      Howard

      ZRX1200

      BTW, ZRX carbs have the same spacing as the XS11... http://www.xs11.com/forum/showthread.php?t=35462

      Comment

      Working...
      X