Tweet
I was looking at TopCat' post about the final drive mod, and am wondering about the inside and outside dimensions of the spacer for the xs11 drive shaft?
-
I've been in more than one Hemisphere, and I wrote a book to help you do it too (or just prepare better for that week long road trip). Going Small, not just for the little guys. -
Read this...
Anything you need to know on the final drive swap.
http://www.xs11.com/forum/showthread...udos+to+xschop -
Hey Pain,
First of all, I just RE-Posted it, it was XSChop and Maximan that did the research and work on it, they get the credit!
Secondly, what is needed is a 3/4" pipe coupling, the OD of the splines are listed to be 7/8", the wall thickness of the coupling is only about 1-2mm! HTH? Page 17 in that thread John posted is where they talk about what can be used!
T.C.T. C. Gresham
81SH "Godzilla" . . .1179cc super-rat.
79SF "The Teacher" . . .basket case!
History shows again and again,
How nature points out the folly of men!Comment
-
That was the thread I was looking for when I searched, got yours instead.
Thanks. Give me a week or two and I will tell everyone how it went, though I am "cheating" and having my wrench handle the swap.
Then I will just need an aux fuel tank
I've been in more than one Hemisphere, and I wrote a book to help you do it too (or just prepare better for that week long road trip). Going Small, not just for the little guys.Comment
Comment