Greetings, first post on the board so be nice. I've searched through existing posts and have plenty of ideas on the bad gas mileage issue (around 20mpg), my carbs certainly need a cleaning/rebuild. I have also recently had a serious "vapor lock" type issue. Last time I was driving home from work, after about 6 miles of highway the bike completely died, pulled over, waited 3-4 minutes, starts up, rides for another couple of miles, dies. Repeat all the way home.
81 XS1100
32k
recent routine maintenance completed (plugs, filters, inline fuel filters, etc)
I have ridden about 200 miles since I purchased the bike with only one previous stall of similar nature on a cold, damp morning. That's Colorado summer cold, about 65 degrees @ 6AM.
It appeared to be heat provoked as it was quite hot that day, however I was not in traffic and it did the same thing once on the drive in to work in the morning as well, again, summer cold.
The bike appeared to be running fine other than that since I bought it. My only complaint would be lack of power and bad gas mileage. I'm very familiar with automotive work but this is my first bike. Any suggestions are appreciated, thanks in advance.
81 XS1100
32k
recent routine maintenance completed (plugs, filters, inline fuel filters, etc)
I have ridden about 200 miles since I purchased the bike with only one previous stall of similar nature on a cold, damp morning. That's Colorado summer cold, about 65 degrees @ 6AM.
It appeared to be heat provoked as it was quite hot that day, however I was not in traffic and it did the same thing once on the drive in to work in the morning as well, again, summer cold.
The bike appeared to be running fine other than that since I bought it. My only complaint would be lack of power and bad gas mileage. I'm very familiar with automotive work but this is my first bike. Any suggestions are appreciated, thanks in advance.

You definitely have problems IF you have a lack of power!
I'll start with the fuel tank, pet cocks, fuel filters, and carb. I THINK it's running on all 4, but ya know what, I better check. I'll be busy tomorrow that's for sure.
Prom stated! Also, it can just corrode and rust and get stuck, so the vacuum hose may be intact, but the valve isn't moving! So...you can test it along with the petcocks, and you can take it OFF, and take it apart and check out it's innards, and get a repair kit, OR you can just chuck it away and bypass it entirely like many of us have! 

Comment