Announcement

Collapse
No announcement yet.

Octy

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Octy

    I'm thinking about eliminating the octy and looked at the forums on this board.I have Pingel petcocks that have off,on,and res.What do i plug on them?
    1980 XS1100 SG
    Inline fuel filters
    New wires in old coils-outer spark plugs
    160 mph speedometer mod
    Kerker Exhaust
    xschop K & N air filter setup
    Dynojet Recalibration kit
    1999 Kawasaki ZRX1100
    1997 Jeep Cherokee 4.5"lift installed

  • #2
    How many outlets do they have?
    Unless there is a "Prime" you shouldn't have to do much besides remove the extra plumbing.
    You will end up with two fuel inlet lines to the carbs. Just hook 'em up.
    XS1100SF
    XS1100F

    Comment


    • #3
      2 outlets.Looked at a couple of diagrams on this site.No prime on these petcocks.
      1980 XS1100 SG
      Inline fuel filters
      New wires in old coils-outer spark plugs
      160 mph speedometer mod
      Kerker Exhaust
      xschop K & N air filter setup
      Dynojet Recalibration kit
      1999 Kawasaki ZRX1100
      1997 Jeep Cherokee 4.5"lift installed

      Comment


      • #4
        this is a totally different thread, but TC put up the Octopus diagram.
        Cap off vac port on carb boot.
        Can reuse "tee's". short line from carb to tee, then one to "on" and other to "reserve".

        http://www.xs11.com/forum/showthread...5&pagenumber=2


        mro

        Comment


        • #5
          Yeah, what mro said.
          If the reserve and run are separate, you need to tee them.
          XS1100SF
          XS1100F

          Comment

          Working...
          X