Announcement

Collapse
No announcement yet.

plugs

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • #31
    Mikey's

    Part #48-1408 (discard rubber plug in kit)

    Clik below

    http://www.mikesxs.net/mikesxs-fuel_...ategory_id=4.3

    ________________

    if you have never had the carbs off, a good cleaning may be all thats needed, (unless you fubar the float bowl gasket).

    Think it is covered very well in the tech tip's...........



    mro

    Comment


    • #32
      manifolds

      While i'm working on the carbs i'm gonna replace the rubber manifolds where is the place to buy them ?

      Comment


      • #33
        CARB HOLDERS from Partsnmore
        4 Pc. Set. Fits All XS1100 (78-81) & XJ1100 Maxim (82-84) Made in Japan


        $90.00US /Set **FREE SHIPPING**

        Part#48-1466
        Or you can Pay $139.00 for same to OldBikeBarn?
        Or $94.00 +$5.15 S&H from Ebay/Georgefix

        T.C.
        T. C. Gresham
        81SH "Godzilla" . . .1179cc super-rat.
        79SF "The Teacher" . . .basket case!
        History shows again and again,
        How nature points out the folly of men!

        Comment


        • #34
          rubber manifolds

          Wrapped my 80G with electrical tape.
          Look fine from a few feet away

          Do have a new set for my LG and if/when it gets done...
          have parts to cherry out the 80G


          mro

          Comment

          Working...
          X