O-ring size for 1980 carb T's between carbs

[Courtney]

Anyone know off hand what size these are so I order some? De-ganged my carbs today and the T's between them's O-rings are looking about 33 yrs old.

[JeffH]

Anyone know off hand what size these are so I order some? De-ganged my carbs today and the T's between them's O-rings are looking about 33 yrs old.

Just to be sure, for an XS11?? bikerphil had posted Carb Tee Repair thread in the repair section. Check this thread.

http://www.xs11.com/forum/showthread.php?t=36207

I have the T-4 fuel T that Marty referenced. I measure OD at 10mm. ID is 7mm so the P6 ID size will give the snug fit to hold the 'O' in place. Got my carb 3 to 4 T' in ok with the brass T-4. It is a nice upgrade. Plan to do carb 1 to 2 T' later today. The P6 Nitrile that bikerphil shows should do the trick for you. -and yeah, after all those years the T's seals get real nasty, shrink & crack.

Hope that helps!

Jeff