Tweet
Disregard.
-
Last edited by JonnyO; 04-02-2024, 04:54 PM. -
There are downloadable ones here on the site. Some are too large and have to be emailed but one of the admin does that. I will look for a link.
Found it, https://xs11.club/forum/maintenance/...ch-in-jpg-form2-79 XS1100 SF
2-78 XS1100 E Best bike Ever
80 XS 1100 SG Big bore kit but not fully running yet.
Couple of more parts bikes of which 2 more will live! -
Why '80 and not '81...like mine. Or does it simply not matter?
THanks, though!
Comment
-
All of the manuals basically have the same chapters in them for the basics of the bikes. Then addendums are added to address the specific model/year.Originally posted by JonnyO View PostWhy '80 and not '81...like mine. Or does it simply not matter?
THanks, though!2 - 80 LGs bought one new
81 LH
02 FXSTB Nighttrain
22 FLTRK Road Glide Limited
JimComment
-
Lmao! So I ordered one. Couldn't find THAT ONE 'cause I set up a meat slicer in the garage where I had placed the replacement manual. Looked in cupboard for replacement...
LMAO! Found my old ( better condition ) one!Attached FilesComment
-
-
I did the same thing, only it took me twenty years to find my new to me OEM manual I had purchased when I bought my bike. Just wanted to add, there are a few areas in that clymer's manual where the information is incorrect. I wish I could cite exactly where and what. We had a discussion quite a while back that pointed specifically where those were. Maybe someone else will remember and point those out for you. I have a Clymers manual as well and had actually made the corrections in it and low and behold couldn't begin to tell you where that manual is today. I know I still have it, mind you, however just like the other one I misplaced for twenty years I am assuming that is probably what happened to my Clymer manual.Originally posted by JonnyO View Post2 - 80 LGs bought one new
81 LH
02 FXSTB Nighttrain
22 FLTRK Road Glide Limited
JimComment
-
Page 222. It's the torque spec for the swing arm pivot shaft bolts. It's listed as 47 foot pounds but should be 47 inch pounds.Comment
-
I downloaded. I took the pdf file to a place that printed the whole thing on both sides of the paper. I put each sheet in a document protector. The whole mess went in a three ring binder. Greasy fingers are no problem. I like paper copies. It did cost more than $5, but I got what I wanted.Marty (in Mississippi)
XS1100SG
XS650SK
XS650SH
XS650G
XS6502F
XS650EComment
Comment