If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I miss the old Ken Ross valve shim tool. They're no longer made and mine was in a box of tools that was stolen. It was the only tool that after all these years I have not replaced.
I had one made by Kent Moore that hooked under the cam and had a lever on it that pushed a pin to depress the bucket. I can't for the life of me find it, been moving around a lot! Even though that Kent Moore tool was easier than the Motion Pro tool, it's easier still to loosen the whole camshaft rather than repeatedly rotating the crank.
Yes, that's the one. Mine was stolen 20 or so years ago and I had forgotten who exactly made it. What I liked about it was it worked on many brand X bikes too...
I had one made by Kent Moore that hooked under the cam and had a lever on it that pushed a pin to depress the bucket. I can't for the life of me find it, been moving around a lot! Even though that Kent Moore tool was easier than the Motion Pro tool, it's easier still to loosen the whole camshaft rather than repeatedly rotating the crank.
Comment