Announcement

Collapse
No announcement yet.

Carb Swap anyone?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Carb Swap anyone?

    I got a kick out of these guys in the Celica.

    http://www.youtube.com/watch?v=PJIKMN5rjds

    I have a set of zrx carbs hanging in the postal system somewhere that I am going to try and set up on the bike.
    If my jeep wasn't a gas-guzzling 8-cylinder fuel-injected breakdown king, I might just put the Mikunis off the SF on it and fire it around the twisties..

    G.

  • #2
    I saw that a couple weeks ago. To bad there are none of it out running (or running good).
    '81 XS1100 SH

    Melted to the ground during The Valley Fire

    Sep. 12th 2015

    RIP

    Comment


    • #3
      Not even close

      XS11's excelerate SSOOOOOOO much faster than that.
      You can't stay young forever, but you can be immature for the rest of your life...

      '78E "Pathfinder" Show bike...
      Lovingly restored by Dave Delzell
      Drilled airbox
      Tkat fork brace
      Hardly mufflers
      late model carbs
      Newer style fuses
      Oil pressure guage
      Custom security system
      Stainless braid brake lines

      Comment


      • #4
        This must be an improvement over the original carb set-up.
        Check out the snazzy connecter plate between the middle carbs and I may consider trying out that smart looking fuel line cross over.
        Looks/sounds like it idles and revs up cleanly through the intire rev range:

        http://www.youtube.com/watch?v=gHEgdZLj3KI&NR=1
        Last edited by GNEPIG; 04-18-2008, 07:42 AM.

        Comment


        • #5
          carbs

          i always said any thing would run good with mikuni s
          bill hane

          Comment


          • #6
            I liked how neatly they had plumbed in the carbs too. A bit of effort went into setting up the connection plates and the set-up with the fuel feed lines looks neat and not half-assed. What's next.? Big velocity stacks and exhaust tuning? The floor-standing vacuum sync tool looks pretty serious too..

            Comment

            Working...
            X