Tweet
I have too many extra parts I have one complete bike in boxes if anyone needs I have a couple extra complete front ends two motors completely taken apart in boxes. complete set of front and rear calipers and mastercyl. that work just took it off the bike yesterday
-
-
am looking for turn signal switch
Rubber down and the throttle back!!!!1982 xj1100j -
Just got back to work this morning and got your post if you are still interested . I will check tonight and post back to you thanksComment
-
I checked on the turnsignals not in the greatest shape sorryComment
-
do you have the line for the front brake. This cable is connected to the brake light and it is installed at one end of the brake lever. Again it is the cable that turns the brake light on. thanksComment
-
Sorry there wasn't one on the bike when I recieved itComment
-
caliper
I need a rear caliper piston...in good shapeMDRNF
79F.....Not Stock
80G......Not Stock Either....In the worksComment
-
Was trying to sell the complete rear end assyComment
-
I'm in need of the retainers that goes over the fork ears and holds the headlight secure. Their rectangular and has a reflector that faces outward.
Thank you,
JesComment
-
This one had some sort of aftermarket chome light sorryComment
-
what about side covers for 78e and seat hold downs??when in doubt...get a bigger hammer
'78 XS11e, '79 XS11sf,'81 Mazda RX7, '83 XJ650lj Turbo, '95 Ford F150, '93 Chevy K2500, '04 Honda Pilot,
'89 Arctic Cat Wildcat, '89 Arctic Cat El Tigre 530, '81 Arctic Cat Trailcat 340, '79 john deere trailfire 440,
'78 Cadillac Seville
Don't steal the government hates competition
Comment
-
These are in too bad of shape to reuse sorryComment
-
I need a Case, Chain Tensioner. I was re-tensioning the chain when the bolt stripped.Comment
-
Cyrock, that is an easy heli-coil fix. Use the search button at the top of the page and look for 'helicoil' and 'tensioner'Originally posted by Cyrock
I need a Case, Chain Tensioner. I was re-tensioning the chain when the bolt stripped.
Be very careful about turning over the motor only by hand until you get the tensioner fixed. If you try to start it up, and the chain is worn, there is a high risk of the chain jumping a tooth, and this will cause bent valves. You want to avoid this!
Ken TalbotComment
-
Thanks Ken - I've not turned the engine over since I set the timing mark. I guess my next question is where I could find a helicoil kit?Comment
Comment