My patience has come to an end :evil:
TITLE IN HAND!
the bike will start and run but is not rideable due to the clutch being frozen (from gas in oil incedent) I did drive the bike home over 3 weeks ago
New battery
just did a level 1 cleaning of the carbs
front tire is %90 back is %60 no cracking on either
Seat is in very good condition no cracks or rips
paint is shot! plus i found bondo on the lower right side of gas tank ther is a little rust in the tank
New in line filters
it has 3 pods one is missing
I did ride the bike home and even after sitting for a winter outside it had power
4 new spark plugs
missing front left caliper PO stated back one was rebuilt last year (it works)
the fenders are starting to rust but will clean up
the fork tubes have rust high up near the neck but i did clean some of it off and looks good
clipped the ends of 3 stock wires and put 1 new on
3 quarts of fresh 20/50 for motor cycles
make a long story short there are 3 stock wires on the coils and 1 new one (#2) #3 will have Tobe soldered (it is on there but only twisted on)
$600 PM if interested
TITLE IN HAND!
the bike will start and run but is not rideable due to the clutch being frozen (from gas in oil incedent) I did drive the bike home over 3 weeks ago
New battery
just did a level 1 cleaning of the carbs
front tire is %90 back is %60 no cracking on either
Seat is in very good condition no cracks or rips
paint is shot! plus i found bondo on the lower right side of gas tank ther is a little rust in the tank
New in line filters
it has 3 pods one is missing
I did ride the bike home and even after sitting for a winter outside it had power
4 new spark plugs
missing front left caliper PO stated back one was rebuilt last year (it works)
the fenders are starting to rust but will clean up
the fork tubes have rust high up near the neck but i did clean some of it off and looks good
clipped the ends of 3 stock wires and put 1 new on
3 quarts of fresh 20/50 for motor cycles
make a long story short there are 3 stock wires on the coils and 1 new one (#2) #3 will have Tobe soldered (it is on there but only twisted on)
$600 PM if interested