If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Just let me know when you might be in the area, and watch out for low flying student driven aircraft
I was talking about swingin by old san antone. Your down below montgomery I believe. Of course that would be the long way back. I got a feeling Ill get Gregs share of the beer no matter what.
Dont worry, Greg wont come to Alabama. I tried to get him to when I was there. ( unless he is scared of me?)
Im gonna ride to memphis the 23rd to sons graduation. Will most likely swing by on way back. Hell its just a skip and jump from here.
You will get Greg's share of the beer then
Just let me know when you might be in the area, and watch out for low flying student driven aircraft
Dont worry, Greg wont come to Alabama. I tried to get him to when I was there. ( unless he is scared of me?)
Im gonna ride to memphis the 23rd to sons graduation. Will most likely swing by on way back. Hell its just a skip and jump from here.
Dont worry, Greg wont come to Alabama. I tried to get him to when I was there. ( unless he is scared of me?)
Im gonna ride to memphis the 23rd to sons graduation. Will most likely swing by on way back. Hell its just a skip and jump from here.
You STILL haven't gotten a seal? What electical gremlin?
Don't make me come on over there.
I have beeeer....
Summit sent me a nice little card saying it would be another three weeks before they even get the oil seal in..and from there, they still have to ship it to me. So I broke down and went back to Napa, yelled at them for putting the wrong seal in the wrong box, and they reordered it. So we will see what comes in tomorrow. Being as it took them 3 weeks and four tries to get me the proper CV shaft for a car a couple years ago, I am not holding out much hope.
As for the electrical issue, that is on hold until the seal comes in, since I can't troubleshoot it till I can turn the engine over. And that is just the bike not getting spark. I did check the pick up coil wires, all seem good there. Anyway, I have a thread on all this somewhere.
But I am just one voice...where is everyone else who could attend this little rally??
If I can ever get the proper oil seal and track down the electrical gremlin, I might try to make it out there. Pushing my bike the whole way would wreck hell on my riding boots
I ain't too scary, I guess it depends on who you ask though.
Here's a pic from last summer at the Lost Rally in Wisconsin. DragonSlayer on the left and Bigfoot on the right and that scary good lookin' XSive in the middle is me.
The storekeep there ran us off because he thought we were scaring the customers away..................I think it was DragonSlayer.
Leave a comment: